Connections; F-Series Endpoints - Transmitter Operation Mode - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
3. Installation 3. Installation
3.3. Connections
3.3.1. F-series Endpoints - Transmitter Operation Mode
Connections for the F110 model in transmitter operation mode
Changing the Operation Mode
The operation mode of the UBEX endpoint device can be changed using the following methods:
▪ via front panel LCD menu - see the details in the
▪ via Lightware Device Controller (LDC) software - see the details in the
▪ via LW3 protocol command - see the details in the
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
Operation Mode section;
Status Tab section;
Set the Operation Mode section.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
Connect singlemode or multimode (depends on the installed SFP+ modules)
OPT
DAC fiber optical cables or DAC cables between the two UBEX endpoint devices. The
Extender Mode is detected and applied automatically in the device once the
connection is established successfully.
HDMI in Connect the transmitter and the source devices (e.g. PC, Blu-ray player) using
the HDMI input 1 and 2 ports by HDMI cables.
Local HDMI out Connect the local sink devices (e.g. monitor, 4K TV) to the HDMI output 1 and 2
ports by HDMI cables. The ports transmit the original streams of the HDMI
input ports.
Ethernet Optionally connect the transmitter to a LAN in order to control the device.
Power Connect the power adaptor to the AC input on the transmitter first, then to the
AC power socket.
Audio in Connect an audio source device (e.g. media player) to the audio input connector.
Audio out Connect an audio sink device (e.g. active speakers) to the audio output
connector.
IR in Connect an Infrared detector unit to the IR IN connector for receiving Infrared
input signal.
IR out Connect an Infrared emitter unit to the IR OUT connector for controlling third-
party devices over Infrared signal.
RS-232 Optionally for RS-232 extension: connect the controlled unit (e.g. 4K TV) to the
RS-232 port of the device with a serial cable.
WARNING!
User Ethernet is also transmitted over the SFP+ interface so be sure not to create network
loop!
23 23