Register Description - Siemens ERTEC 200P-2 Manual

Register Description

2.3.10.8.6
The data-bus-width of all specified registers in this module is: 32.
A '0' is read from Software for each not specified Bit in the registers.
The addressing is organized: WORD – wise
Module: /gpio
Register: GPIO_IOCTRL_0
Bits: 31dt0
Description:
Register: GPIO_OUT_0
Bits: 31dt0
Description:
Register: GPIO_OUT_SET_0
Bits: 31dt0
Description:
Register: GPIO_OUT_CLEAR_0
Bits: 31dt0
Description:
Register: GPIO_RES_DIS_0
Bits: 31dt0
Description:
Copyright © Siemens AG 2016. All rights reserved
Technical data subject to change
Reset value:
Configuration register for General Purpose IOs (31:0)
0: GPIOx = output, 1: GPIOx = input
Reset value:
Output register for General Purpose IOs (31:0)
0: GPIO outputx = 0, 1: GPIO outputx = 1
Reset value:
Bit-selective setting of the output register for General Purpose IOs
(31:0)
For writing:
0: GPIO outputx remains unchanged
1: GPIO outputx = 1
Read always returns 0
Reset value:
Bit-selective reset of the output register for General Purpose IOs
(31:0)
For writing:
0: GPIO outputx remains unchanged
1: GPIO outputx = 0
Read always returns 0
Reset value:
Bit-selective reset disabling of XRESET_GPIO_SM signal for
registers of General Purpose IOs (31:0)
357
FFFFFFFFh
00000000h
00000000h
00000000h
00000000h
Address: 0h
Attributes: r w
Address: 4h
Attributes: rh w
Address: 8h
Attributes: rh wt
Address: Ch
Attributes: rh wt
Address: 10h
Attributes: r w
ERTEC 200P-2 Manual
Version 1.0