Siemens ERTEC 200P-2 Manual page 287

3dt1 <reserved>
4 CLK_INPUT_SELECT
5 RELOAD_DISABLE
6 DIS_RLD_WHEN_WR_LDREG 0h
7 EXT_GATE_TRIG_ENABLE
8 GATE_POLARITY
9 GATE_EFFECT
10 TIMER_OUT_POLARITY
12dt11 EVENT1_CONTROL
13 EVENT1_INVERSION
15dt14 EVENT2_CONTROL
16 EVENT2_INVERSION
31dt17 <reserved>
Register: TIM_0_PRESCALER_REG
Bits: 31dt0
Description:
Bit Identifier
Copyright © Siemens AG 2016. All rights reserved
Technical data subject to change
0h
0h
0h
0h
0h
0h
0h
0h
0h
0h
0h
0h
Reset value:
Timer PRESCALER Register for Timer 0
Reset
287
not used
Selection of Count-/Load-Clock
0 =CLK_TIMT, 1 =ext. Gate-
r w
/Triggersignal, see also bit
GATE_EFFECT)
Reload Mode disable
r w 0 =Reload Mode is active, 1 =Single
Mode is active
Disable Reload when Writimg Load-
Register
r w
0 =Reload Mode is active, 1 =Single
Mode is active
Selection of Gate-/Trigger signal
0 =INT_GATE_TRIG, 1
r w
=EXT_GATE_TRIG is Gate-/Trigger
signal
polarity of ext. Gate/Trigger signal
r w 0 =high active/rising edge, 1 =low
active/falling edge
Effect of ext. Gate/Trigger signal
0 =Gate-/Count-Mode for
r w CLK_INPUT_SELECT =0/1,1
=Trigger-/Toggle-Mode for
CLK_INPUT_SELECT =0/1
polarity of TIM_OUT
r w
0 =high active, 1 =low active
Effect of EXT_EV1 on External Event
r w
register
Inversion of Event1
r w
0 =not inverted, 1 =inverted
Effect of EXT_EV2 on External Event
r w
register
Inversion of Event2
r w
0 =not inverted, 1 =inverted
not used
00000000h
Attr. Function / Description
Address: 4h
Attributes: (r) (w)
ERTEC 200P-2 Manual
Version 1.0