Pll Clock Generation; Figure 26: Quartz Wiring - Siemens ERTEC 200P-2 Manual

2.3.9.2.1 PLL Clock Generation

As shown in Table 16, ERTEC 200P largely runs with a synchronous 125 MHz or 250 MHz
clock. These clocks are generated with an integrated PLL. The PLL is supplied with a 25
MHz clock signal. The PLL clock source is an integrated quartz oscillator, to which an
external 25 MHz quartz must be connected (CLKP_A/B). Alternatively, an external 25 MHz
generator can be connected to the CLKP_A pin.
The external quartz wiring is shown in Figure 26 (the capacity and resistor values given
here are valid for the TSX-3225 quartz types from Epson):
The PLL provides 500 MHz at its output. In clock generation downstream from the PLL,
the PLL output frequency is converted into:
125 MHz
250 MHz
125/250 MHz
It is also possible to bypass the PLL with the configuration pin CONFIG(2) (see
2.3.10.9.3). In this case, clock supply is over the BYP_CLK pin. With a recommended
input frequency of 125 MHz, the output clocks are 125 MHz for ARM926EJ-S, system
clock and synchronization. This PLL bypass is only useful for debug operation.
Copyright © Siemens AG 2016. All rights reserved
Technical data subject to change

Figure 26: Quartz wiring

System clock (CLK_SYS)
Synchronization in the PN-IP (CLK_TIME)
ARM926 (CLK_ARM_SLOW/FAST)
237 ERTEC 200P-2 Manual
Version 1.0