Siemens ERTEC 200P-2 Manual page 392

Description:
Bit Identifier
2dt0 PARTITION_TCM926
3 INITRAM
Register:
Bits:
Description:
Bit Identifier
0 INT_POLSEL_GPIO0
1 INT_POLSEL_GPIO1
2 INT_POLSEL_GPIO2
3 INT_POLSEL_GPIO3
4 INT_POLSEL_GPIO4
5 INT_POLSEL_GPIO5
Copyright © Siemens AG 2016. All rights reserved
Technical data subject to change
TCM926 Map Register
Division into I / D-TCM and INITRAM
Reset
xh
xh
GPIO_INT_POLSEL
31dt0 Reset value: 0h
Interrupt polarity for GPIO interrupts (15:0)
Reset
xh
xh
xh
xh
xh
xh
392
Attr. Function / Description
I-TCM / D-TCM ARM926
000b: 0 KByte / 256 KByte
001b: 64 KByte / 192 KByte
r w
010b: 128 KByte / 128 KByte
011b: 192 KByte / 64 KByte
100b: 256 KByte / 0 KByte
Booting I-TCM
0: I-TCM not booted. Booting in ac-
cordance with MEM_SWAP configu-
r w
ration.
1: I-TCM is activated after ARM926
core reset
Address: 60h
Attribu-
tes:
Attr. Function / Description
0: GPIO0 is not inverted from the A-
ICU (IRQ32) and GDMA
r w
1: GPIO0 is inverted from the A-ICU
(IRQ32) and GDMA
0: GPIO1 is not inverted from the A-
ICU (IRQ33) and GDMA
r w
1: GPIO1 is inverted from the A-ICU
(IRQ33) and GDMA
0: GPIO2 is not inverted from the A-
ICU (IRQ34) and GDMA
r w
1: GPIO2 is inverted from the A-ICU
(IRQ34) and GDMA
0: GPIO3 is not inverted from the A-
ICU (IRQ35) and GDMA
r w
1: GPIO3 is inverted from the A-ICU
(IRQ35) and GDMA
0: GPIO4 is not inverted from the A-
ICU (IRQ36) and PN-ICU 1
r w
1: GPIO4 is inverted from the A-ICU
(IRQ36) and PN-ICU 1
r w 0: GPIO5 is not inverted from the A-
r w
ERTEC 200P-2 Manual
Version 1.0