2.3.10.8.2
Integration of the GPIO Module
The GPIO module connects the top level modules to the GPIO pins. It is also connected
to the APB bus. The GPIO module is operated with the APB clock.
The feature of an internal GPIO "reset disable" is activated in ERTEC 200P (module
input: XRESET_HW
(XRESET_GPIO_SM), a selective reset in GPIO_SM is also possible.
The connection of the internal modules to the GPIO module (GPIO_XOE_F_A/B/C,
GPIO_OUT_F_A/B/C, GPIO_IN_F_A/B/C, GPIO_IN_F_A/B/C_BLOCK signals) is de-
scribed in the corresponding modules and in GPIO assignment.
Module 1
Module 2
Module 3
Copyright © Siemens AG 2016. All rights reserved
Technical data subject to change
connected to reset signal). Alongside the global
GPIO_XOE_F_A(k)
GPIO_OUT_F_A(k)
GPIO_IN_F_A(k)
GPIO_IN_F_A_BLOCK(k)
GPIO_XOE_F_B(k)
GPIO_OUT_F_B(k)
GPIO_IN_F_B(k)
GPIO_IN_F_B_BLOCK(k)
GPIO_XOE_F_C(k)
GPIO_OUT_F_C(k)
GPIO_IN_F_C(k)
GPIO_IN_F_C_BLOCK(k)
Figure 44: GPIO, IO Circuit
352
GPIO
GPIO_XOE(k)
GPIO_DO(k)
GPIO_DI(k)
reset
Pad
ERTEC 200P-2 Manual
Version 1.0