Quantum Scalar i6000 Installation Manual page 60

a. Loosen screws 3 through 10 on the middle X-axis rail that is out of alignment.
Do not loosen screws 1 and 2 or the rail-to-rail alignment will be lost.
Note
1 2 3
middle
X-axis rail
b. Adjust the X-axis rail until the level matches that of the control module, then tighten screw 10.
c. Verify that the rail is still within tolerance, then tighten the remaining screws.
d. Repeat Step 4
If you need to attach and align the middle X-axis rail in another expansion module, go to
Middle X-Axis Rail on page 43.
48
4 5 6
for each expansion module. The X-axis rails should now be level.
7 8 9
Installing a Multi-Module Library
10
X-axis
channel
Attaching the