Adding A Power Supply Chassis - Quantum Scalar i6000 Installation Manual

Adding a Power Supply Chassis

Required tools: 7 mm socket wrench, ESD strap
1 Shut down the library.
For more information, see
2 Open the service door on the control module or expansion module where you are adding the power
supply chassis.
3 Attach the ESD strap to your wrist and to an unpainted surface inside the door.
4 On the power distribution unit(s), set the circuit breaker switch to the down (0) position.
5 Remove the four thumbscrews retaining the cover plate from the power chassis opening.
thumbscrews
6 Remove the LBX cover plate.
7 Unpack the power chassis.
240
Shutting Down the Library
thumbscrews
on page 232.
Adding Optional Hardware