Installing A Stand-Alone Control Module - Quantum Scalar i6000 Installation Manual

Installing a Stand-Alone Control Module

This chapter describes how to install a stand-alone control module. To install a new multi-module library or
add expansion modules to an existing control module or multi-module library, see
Library on page 27.
To install a stand-alone control module, complete the following procedures:
• Positioning the Stand-Alone Control Module
• Lowering the Leveling Legs
• Raising the Control Module Off the Casters
• Testing the Digital Level
• Verifying Level Condition
• Additional Leveling
• Setting the Leg Lock Nuts
Required tools:
• 24 mm open end wrench
• 16 mm open end wrench
• 6 mm hex wrench
• Digital level
Scalar i6000 Installation Guide
on page 20
on page 22
on page 23
on page 24
on page 25
on page 20
on page 21
Installing a Multi-Module
19