Quantum Scalar i6000 Installation Manual page 211
Tape library
Hide thumbs
Also See for Scalar i6000:
- User manual (738 pages) ,
- Planning manual (92 pages) ,
- Manual (58 pages)
Table of Contents
Advertisement
5
Click a blade to highlight it, and then click Configure.
The FC Port Failover dialog box appears.
6
In the Feature Enable area, select Enable FC Host Port Failover, and then click Set to make the
Configuration tab available.
On the Configuration tab, settings are unavailable if the current state of
Note
the tab is set to Disabled.
Be aware that there might be incompatibilities with channel zoning
configuration on the I/O blade if you enable host port failover. Both target
ports must have the same ports mapped.
7
Accept the recovery setting default values unless an authorized representative advises you otherwise.
Scalar i6000 Installation Guide
199
Advertisement
Table of Contents
Need help?
Do you have a question about the Scalar i6000 and is the answer not in the manual?