Setting Up Notification - Quantum Scalar i6000 Installation Manual

The password specified must be valid for the specified account at the
Note
named SMTP server.
• Sender Address—for example, MyLibrary@MyCompany.com
The library uses this address in the "From" field of e-mail messages that it sends out, indicating the
originator of the message. If you type, for example, "scalari6000", the library appends the domain
information (for example, "@mycompany.com"). If you type, for example,
"scalari6000@mycompany.com", the library does not append any additional information.
3 To test the e-mail configuration, type an e-mail address in the Recipient box of the Test Current
Configuration area and click Test email.
4 Confirm that the library displays a message indicating that the test completed successfully and sends
a test message to the specified e-mail address.
5 The subject of the test message should be "Test email from Scalar i6000" and the message text should
include the library name, version, and serial number, along with the date and time that the message was
sent.
6 Click OK.
Proceed to

Setting up Notification

Setting up Notification
The Notification command allows you to send e-mail to specific individuals whenever certain conditions
occur. The information in the e-mail notification provides details about the issue and the library conditions
at the time of the error.
1 Complete the steps in
2 Click Setup→ Notification→ System Setup.
The System Setup Notification dialog box appears with the Contact Information tab displayed.
Enter the contact information you want included in an e-mail notification if an error occurs in the library.
Scalar i6000 Installation Guide
on page 171.
Setting up E-mail on page 170, unless you have already done so.
171