Quantum Scalar i6000 Installation Manual page 339

8 After you complete the questionnaire, click Next.
The following dialog box appears.
9 Insert a "scratch" cartridge into the I/E station, and then click Next.
• Make sure that your scratch tapes are formatted and contain no data that
Note
cannot be overwritten. Scratch tapes must have barcode labels with valid
volume serial (volser) numbers on them. Also, you might find it useful to
write down the volser number so that you can identify your scratch tapes.
• This procedure will not damage any cartridges that are already installed
in the library. You can load both LTO and DLT scratch cartridges if your
library has mixed media.
• If the scratch cartridge becomes lodged in a drive or magazine, it must be
manually removed from the library. If not removed, the cartridge will
become part of the partition the next time the accessor assembly is
enabled.
The I/E station will be locked until the inventory is complete.
Scalar i6000 Installation Guide 327