Interpreting Lbx Terminator Leds; Lbx Terminator Version 01 Leds; Table 27 Explanations Of Lbx Terminator Led States (Version 01); Figure 48 Locations Of Lbx Terminator Leds (Version 01) - Quantum Scalar i6000 Installation Manual

Interpreting LBX Terminator LEDs

The LBX terminator has two versions. Version 01 has four LEDs and Version 03 has six LEDs. For more
information, see LBX Board and Terminator

LBX Terminator Version 01 LEDs

The LBX terminator has four green LEDs that indicate the presence of modules in the library.
shows the locations of the LEDs.
The terminator must be located in the LBX of the last expansion module. The LED status should reflect the
physical installed module count of the system.
Figure 48 Locations of LBX Terminator LEDs (Version 01)
4
3
2
1
Table 27 Explanations of LBX Terminator LED States (Version 01)
LED On/Off Combinations
1 2 3
Off Off Off
On Off Off
On On Off
On On On
On On On
On Off On
On On Off
On Off On
On Off Off
362
on page 345.
Table 27 describes how to interpret LED activity on the LBX terminator.
4
Off Robotics are disabled, the access door is open, or the LBX
terminator is misaligned.
Off The library has one control module and no expansion modules.
Off The library has one control module and one expansion module.
Off The library has one control module and two expansion modules.
On The library has one control module and three expansion modules.
On The library has one control module and four expansion modules.
On The library has one control module and five expansion modules.
Off The library has one control module and six expansion modules.
On The library has one control module and seven expansion modules.
Explanation
Interpreting LED Codes
Figure 48