Initial Setup Procedure Road Map - Quantum Scalar i6000 Installation Manual

Initial Setup Procedure Road Map

This section provides a road map for initial installation of a library. A library includes one control module and
may include up to eleven expansion modules. The proper sequence for setting up a library is illustrated in
the following flowchart. Pointers to the instructions are provided to the right of the flowchart.
start
prepare and
inspect library
type
of
installation?
install
stand-alone
control module
install new
multi-module
library
add expansion
module
install tape
drives and
blades
turn on power
A
Scalar i6000 Installation Guide
on page 9
Getting Started
inspect the library. You will use the instructions supplied
with the modules to perform the unpacking procedures
Installing a Stand-Alone Control Module
provides instructions for installing the control module.
Each configuration must contain one control module
Preparing to Install a New Multi-Module Library
page 28 and Adding an Expansion Module to an
Existing System Unit on page 36 contain the
instructions for installing a control module and up to a
total of eleven expansion modules.
Adding an Expansion Module to an Existing System
Unit on page 36 contains the instructions for adding
expansion modules to an existing library, up to a total
of eleven expansion modules.
Installing Drives and Blades
instructions for installing and connecting the tape
drives in the drive modules.
Applying Power on page 93, contains instructions for
applying power to your library.
, describes how to prepare and
on page 19
on
on page 97 provides
.
,
.
11