Table 12 Automatic E-Mail Notification - Quantum Scalar i6000 Installation Manual

❑ Verify the proper Time and Date is established within the library. Click Setup→ Date and Time. The
following entries are visible from this screen:
• NTP Setting ________________
• Server Address 1 ________________
• Server Address 2 ________________
• Date ________________
• Time ________________
• Time Zone ___________________
❑ Verify proper e-mail configuration.
1 Click Setup→ Email Configuration to verify that the e-mail server is configured correctly.
2 Click Setup→ Notification. Each Severity has an associated list of addresses to send automatic
notification messages. Severity 1 should contain
addresses. Severity 2 – 3 are optional and can be disabled in certain library firmware levels. (Note: 4
columns are provided for convenience, there is no requirement for or limitation to 4 entries).
Table 12 Automatic E-mail Notification
Severity e-mail 1
1 techsup@quantum.com
2
3
3 Send an e-mail to an address specified by the customer system administrator to confirm end-to-end e-
mail functionality. Go to Monitor→ System. Select Send and type in the e-mail address.
❑ Verify that the Physical Library is properly set up. The library's default configuration is to Disable
Automatic Teach and Automatic Inventory. This setting is recommended to save start up time during a
library power on or a Robotics Enable. If a customer will be routinely performing bulk load operations or
removing/installing media without using the I/E station, it is recommended that Automatic Inventory be
enabled.
• Automatic Teach _____Enable______Disable
• Automatic Inventory_____Enable______Disable
• Logical SN Addressing_____Enable______Disable
• Automatic Drive Unload_____Enable______Disable
Scalar i6000 Installation Guide
techsup@quantum.com
e-mail 2 e-mail 3
and any customer specified
e-mail 4
333