Ip Address Setting; Ip Address Setting Of Your Pc - Omron K6CM User Manual

4 Introduction of the Motor condition monitoring Tool
4-3

IP Address Setting

4-3-1

IP Address Setting of Your PC

Before starting this tool and monitoring and logging the K6CM device, it is necessary to set the IP
address of the computer to the IP address of the same segment as the K6CM device. It shows the pro-
cedure.
Note that when setting only the K6CM device (IP address and other settings) with an automatic connec-
tion, it is not necessary to set the IP address on the computer side.
For the initial setting of K6CM, refer to "4-3-2 IP Address Setting of the K6CM Devices on page 4-26"
• Windows 7
1
Select [Start] | [Control Panel] | [Network and Sharing Center] | [Change Adapter Settings].
2
Right-click [Local Area Connection] and select [Properties].
3
Select [Internet Protocol Version 4 (TCP / IPv4)] and click [Properties].
Check "Use next IP address" and manually set IP address of the computer.
• Windows 8.1
1
Right-click [Start].
2
Select [Network connection].
3
Right-click [Ethernet], and click [Properties].
4
Select [Internet Protocol Version 4 (TCP / IPv4)] and click [Properties].
Check "Use next IP address" and manually set IP address of the computer.
• Windows 10
1
Click [Start] and select [Windows System Tools] | [Control Panel].
2
Select [Network and Sharing Center] | [Change adapter settings].
3
Right-click Ethernet and click Properties.
4
Select [Internet Protocol Version 4 (TCP/IPv4)] and click [Properties].
Check "Use next IP address" and manually set IP address of the computer.
4 - 24
K6CM Motor Condition Monitoring Device User's Manual (N219)