Omron K6CM User Manual page 107

 IP Address Settings Example
When using Ethernet for the first time, if you set the IP address and subnet mask of the computer
and K6CM device as below, it is possible to connect the software tool to the K6CM device.
Device name
Computer
K6CM device 1st Unit
K6CM device 2nd Unit
K6CM device 3rd Unit
•
•
K6CM device 30th Unit
When the subnet mask is "255.255.255.0", the range of IP addresses that can be set for the device
is 192.168.250.1 to 192.168.250.254. Assign IP address in this range to each K6CM device.
The same IP address can not be assigned to more than one device.
The default value of the IP address of type K6CM device is "192.168.250.10" common to all models.
With the subnet mask of all K6CM devices set to "255.255.255.0", Ethernet communications
can be performed because devices are in the same network (i.e., segment), if an IP address
is between 192.168.250.1 and 192.168.250.254.
Network of 192.168.250.×××
Computer
IP address 192.168.250.100
Ethernet communications
can be performed because
the K6CM devices are in
the same network.
K6CM device
IP address 192.168.250.1
K6CM Motor Condition Monitoring Device User's Manual (N219)
4 Introduction of the Motor condition monitoring Tool
IP address Sub-net mask
192.168.250.100 255.255.255.0
192.168.250.1 255.255.255.0
192.168.250.2 255.255.255.0
192.168.250.3 255.255.255.0
•
•
192.168.250.30 255.255.255.0
Ethernet
communications can
not be performed
because the K6CM
devices are in a
different network.
Default gateway
Blank
No change required (0.0.0.0)
No change required (0.0.0.0)
No change required (0.0.0.0)
•
•
No change required (0.0.0.0)
Network of 192.168.249.×××
K6CM device
IP address 192.168.249.1
•
•
4
4 - 25