Setting Parameters And Setting Values - Omron K7DD User Manual

6 Using K7DD Parameters
6-2 Setting Parameters and Setting
Values
 Setting parameters
The setting items on each level are called "setting parameters."
The setting parameters can be switched over with the Mode Key (M).
The setting parameters can be switched over among CH1, CH2, and CH3 with the Channel Key (U).
Parameters of CH1
Setting parameter 1
Setting parameter 2
Setting parameter 3
 Display or Change of Setting Value
Go through the following steps to display or change the setting value.
1.
Press the Mode Key (M) several times to display the setting
parameter to change.
•
The setting parameter characters are displayed on the main
display.
2.
Use the Shift Key (S), the Up Key (U), or the Down Key (D)
to change the setting value.
•
If no key operation is performed for 5 seconds, the setting value
will be saved.
3.
Press the Mode Key (M) to move to the next setting parameter.
•
The changed setting value is saved in the internal memory.
6 - 4
Parameters of CH2
Setting parameter 1
M Less than 1 s
Less than
1 s
Setting parameter 2
M Less than 1 s
Setting parameter 3
M Less than 1 s
Parameters of CH3
Setting parameter 1
M Less than 1 s
Less than
1 s
Setting parameter 2
M Less than 1 s
Setting parameter 3
M Less than 1 s
M
S U
M
Power Line Data Generator User's Manual (N233)
M Less than 1 s
Return to
CH1
parameter
M Less than 1 s
M Less than 1 s
16*0
rms .[
a
D
16!0
rms .[
a
15%0
rms .{
a