Omron K6CM User Manual page 131

Recommended adhesive is Super XG NO. 777 made by Cemedine Co., Ltd.
We evaluates with this recommended adhesive.
Super XG NO. 777 is a one-pack elastic adhesive based on acrylic modified silicone resin.
3
After waiting for 1 minute, paste the adhesive attachment with the motor's flat surface.
4
Dry for 24 hours, mount the tip of the vibration sensor head to the screw hole. (Recommended
tightening torque 4.4 to 5.4 N•m).
Procedures 2 to 4 are mounting methods when the recommended adhesive is used.
5
Connect the sensor head to the pre-amplifier before mounting it to the motor.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Adhesive attachment
Mounting vertically
Mating mark
5 Installation and Wiring
Motor's flat surface
Adhesive attachment
Motor's flat surface
5
5 - 11