Omron K6CM User Manual page 287

2
Starting the EtherNet/IP network setting screen
Select [File] | [Create New (N)] | [EtherNet/IP] from the menu bar.
3
Installing EDS Files
To configure K6CM as an EtherNet/IP tag data link communications target, install the EDS file
containing the configuration information of the K6CM in the Network Configurator. Once this
installation is done, this operation is unnecessary from the next setting.
This operation is unnecessary with Network Configurator Ver.3.69a or later because the file
comes pre-installed.
If you are using an earlier version, install using the EDS file which is stored on the CD bundled
with the K6CM device. EDS files can also be downloaded from our I-Web.
Register the CIP revision corresponding to the EIP version on the side label of the K6CM
device.
EIP version
Ver.1.0
Ver.1.1
Ver.1.2
K6CM Motor Condition Monitoring Device User's Manual (N219)
Major revision
1
2
3
MAIN: Main cpu version
EIP: Eip cpu version
MES: Mes cpu version
CIP revision
Revision on the Hardware list
Rev1
Rev2
Rev3
Appendices
A
A - 27