Omron K6CM User Manual page 120

4 Introduction of the Motor condition monitoring Tool
When confirming the IP address of the registered device
If you want to check the IP address of the device registered on the project, perform the following opera-
tions.
1
Select the device you want to change and click the
screen tool button.
The following [K6CM Configuration setting] Dialog Box is displayed.
Note The IP address displayed here is the value registered in the project.
Version Information
With software tool version 1.2.0.0 or later, the column for displaying the IP addresses of your
PC and registered devices are displayed.
When changing the IP address of the device
When changing the IP address of the device
1
Select the device you want to change and click the
screen tool button.
The following [K6CM Configuration setting] Dialog Box is displayed.
2
Change the IP address. Change the subnet mask and default gateway as necessary.
3
Click the [OK] Button.
The IP address setting on the project is changed, and at the same time, the IP address of the
actual device at the communications destination is automatically changed.
Version Information
With software tool version 1.2.0.0 or later, the column for displaying the IP addresses of your
PC and registered devices are displayed.
4 - 38
[Device setting] Button on the setting
[Device setting] Button on the setting
K6CM Motor Condition Monitoring Device User's Manual (N219)