Omron K6CM User Manual page 70

3 Measuring and monitoring System
Precautions for Correct Use
In the upper limit alarm, if Critical threshold
threshold
performed when only the value exists. It is as follows.
Numeric LCD display
Transistor Output 1
(At the normally
closed * 2)
Transistor Output 2
(At the normally
closed * 2)
The above is an example in which the alarm latch is disabled and the trigger mode is Free run
(without trigger), but in other cases the threshold of Warning is ignored.
3 - 16
Warning threshold, Warning threshold is ignored and Critical threshold operation is
≥
Measurement value
Warning level
Critical level
Power ON
(*1)
Alarm bar Green
Measurement value displayed
Status display
ON
OFF
ON
OFF
*1. In the above figure, the power-ON state and the unmeasured state (i.e., the state
until the measurement value is calculated) that exist immediately after turning ON
the power as shown on page 3-7 are omitted.
*2. The transistor output type of output 1 and output 2 can also be set to "Normally
Open". In the case of Normally Open, ON/OFF is opposite to the above.
Warning threshold, lower critical alarm, Critical
≤
Since Warning level ≥ Critical level,
it is the same operation as when
Warning level does not exist.
Red Green
"MON"
K6CM Motor Condition Monitoring Device User's Manual (N219)
Time