Omron K6CM User Manual page 213

 Insulation resistance type (K6CM-ISM)
Attri-
Parameter name
bute ID
6E hex Circuit topology
6F hex Using inverter
70 hex Inverter special mea-
surement
71 hex Insulation resistance
failure warning
72 hex Insulation resistance
failure critical
73 hex Reserved area
74 hex Reserved area
75 hex Reserved area
76 hex Reserved area
77 hex Reserved area
78 hex Reserved area
K6CM Motor Condition Monitoring Device User's Manual (N219)
8 Monitoring and Setting Using the EtherNet/IP Devices
Description
Sets the applied circuit.
0: Three-phase three-wire sys-
tem, S-phase grounding
1: Three-phase four-wire sys-
tem, N-phase grounding,
delta connection load
Sets the presence or absence of
the inverter.
0: OFF (No inverter)
1: ON (with inverter)
Sets the inverter special measure-
ment.
0: OFF
1: ON
Special calculation to do when
inverter frequency and commercial
frequency are close.
Note : Using inverter = "with
inverter" only valid
For how to use this function, refer
to the Wiring Diagram of the Insu-
lation Resistance Type (K6CM-IS)
on page 5-27 in 5-6 I/O wiring on
page 5-25.
Sets the Insulation resistance fail-
ure warning threshold.
0 to 9999 (unit: 0.001 MΩ)
(0000 to 270F hex)
Sets the Insulation resistance fail-
ure critical threshold.
0 to 9999 (unit: 0.001 MΩ)
(0000 to 270F hex)
Reserved area
Reserved area
Reserved area
Reserved area
Reserved area
Reserved area
Data
Attri-
bute
Data type Default value
Write UINT 0000 hex
Write UINT 0000 hex
Write UINT 0000 hex
Write UINT 0320 hex (800)
Write UINT 0190 hex (400)
Write UINT 0000 hex
Write UINT 0000 hex
Write UINT 0000 hex
Write UINT 0000 hex
Write UINT 0000 hex
Write UINT 0000 hex
8
8 - 23