Omron K6CM User Manual page 88

4 Introduction of the Motor condition monitoring Tool
Log file example
The display example of the log file concerning the degradation level 1 with the comprehensive current
diagnosis type is shown below.
When the monitoring cycle setting of the software tool is set to 86,400 seconds (= 1 day) ...
Data is saved
every day.
The degradation level 1 pv exceeded the degradation level 1 failure warning and an alarm was output.
The Main body status and the degradation level status have changed according to those states.
For the Main body status and the individual monitoring status, refer to the table below.
Main body status
Bit posi-
tion
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
4 - 6
The alarm values which
are set in the K6CM device
are displayed.
Status
Mes cpu error
Mes cpu data flash error
Main CPU error
Main CPU data flash error
Reserved area
Reserved area
Reserved area
Reserved area
Running Time status
Monitoring condition
Reserved area
Reserved area
Trigger input (ON/OFF state of the exter-
nal trigger input)
Tr1 (transistor 1output state)
Tr2 (transistor 2output state)
Tr3 (transistor 3output state)
The status changes depending
on the status of input/output and
measurement values.
If the motor degrades
Bit contents
0
Not occurred
Not occurred
Not occurred
Not occurred
Unreached
Monitoring
stopped
OFF
OFF
OFF
OFF
K6CM Motor Condition Monitoring Device User's Manual (N219)
1
Occurrence
Occurrence
Occurrence
Occurrence
Reached
During monitoring
ON
ON
ON
ON