Setting Parameters - Omron K6CM User Manual

6-2-2

Setting Parameters

Parameter settings can be set in either of the following two ways:
• How to set in the start navigation of project creation
• How to set on the device setting screen after project creation
The following shows the setting method on the device setting screen. For details on how to set it in the
project creation procedure, refer to Procedure for Setting IP Address (when necessary, further param-
eters) on page 4-28.
If the parameter setting during project creation is not completed, set the parameters of each K6CM
device according to the actual system configuration via the hub.
Because each K6CM device already has an IP address, you can access multiple forms K6CM via the
hub from the software tool.
It depends on the following procedure.
1
Connect the software tool to the K6CM.
2
Click the
The following device setting screen is displayed.
3
Select the device whose settings you want to change.
4
Set the parameters. (For details, refer to 6-2 Setting of K6CM Devices on page 6-19.)
5
Click the
6
Click the
ting screen.
K6CM Motor Condition Monitoring Device User's Manual (N219)
6 How to Use the Motor condition monitoring Tool
[Device setting] Button.
[Downloading (PC→device)] Button to write the parameters.
[Device reset] Button on the upper right of the parameter list on the device set-
6
6 - 23