Omron K6CM User Manual page 306

Appendices
(4)-2 Registering All Tag Sets
Check the check box of the network variable to be used as the input tag among the net-
work-published variables and click the [Register] Button, and then the specified tag is dis-
played in the tag set Pane.
If you perform the registering all tag set, the tag set and the tag are displayed as the same
name.
The tag set names displayed can be used as connection settings. (Use these tag set
names, when configuring EtherNet/IP connections using the Network Configurator.)
You can change the tag set names as required.
Also, the tag name displayed under the tag set name must match the variable name regis-
tered as a network variable (input).
Additional Information
If you create connection settings using the Network Configurator, you can share the tag set
names and tag names of the PLC you edit here with the Network Configurator.
(5) Opening the EtherNet/IP Connection Settings (Connection Display)
Click the Connection Button at the upper left of the EtherNet/IP Connection Settings
(Tag Set Display) to display the Connection.
(6) Target Devices Registration to the Connection Settings of the Originator
Register the K6CM devices to the connection settings of the originator device (PLC).
Right click and select [Create New (A)] or click the
Connection Setting Tab Page, Then select the K6CM from the pull-down list as the target
device. (This operation can also be performed by double clicking the K6CM in the [Target
Device] Pane of the Toolbox.)
Next, when setting [Target Variable], if you press [Ctrl] + [Space] key at the same time, the
selectable ID number is displayed, so select the ID number to use.
For [Originator Variable], select the tag set created in "(4) Editing tag set" from the pull
down list and set it.
In [RPI (ms)], from the setting range of the K6CM device (250 ms to 10,000 ms), set the
data send interval from the K6CM device according to the system. Select the [Timeout
Value] from the pull-down list and set it.
A - 46
(New) Button in the EtherNet/IP
K6CM Motor Condition Monitoring Device User's Manual (N219)