6-1-3
Common Menu and Toolbar List
This section describes the following menu and toolbar in the upper left part common to the screen.
Menu tool button
Monitoring bar
Menu tool button
Buttons and tooltips
Create new proj-
ect
Open project
Save the project
file
Save the project
as the specified
name
Exit
Buttons and tooltips
SYSMAC Gate-
way Console
Buttons and tooltips
Display help
menu
Version informa-
tion
K6CM Motor Condition Monitoring Device User's Manual (N219)
6 How to Use the Motor condition monitoring Tool
Outline of operation
Display the screen for setting the configuration.
If the current project has not been saved, a message will be
displayed.
Display "Open file" dialog.
Equivalent to "[K6CM] Open project file" button when the soft-
ware tool is started.
If the current project is not saved, a message will be displayed.
Save over the current project file.
If you create a new file, the Save File dialog will be displayed
and it will be saved with a name.
The "Save file" dialog is displayed.
Save the project with the specified file name.
Exit the software tool.
If the current project has not been saved, a message will be
displayed.
Outline of operation
Launch the SYSMAC Gateway Console screen.
1. Make sure that "Startup" in the "Communication Service"
field is "Automatic" and that "Status" is "Start".
2. In the [Network Port] field, configure the network port to be
connected.
3. In the [Network Port] field, set the [Auto open] column of the
network port to be used to "Automatic".
Outline of operation
Displays the User's Manual.
The version information screen is displayed.
Enable / disabled condition
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Enable / disabled condition
Selectable during monitoring
execution (grayed out)
Enable / disabled condition
----
----
6 - 11
6