Sample Program Execution Procedures - Omron K6CM User Manual

8-4-3

Sample Program Execution Procedures

The following is the procedure to execute the sample program.
1
IP Address Settings of Devices
The setting method depends on the device. Set as follows:
K6CM:
PLC:
PC:
2
Network configuration
Configure each device refering to the network configuration example described in 8-4-1 Sample
Program Overview on page 8-30.
3
Importing the Sysmac Studio Project File
To import the sample program project file, perform one of the following:
(1) Double-click the project file (.smc2, .csm2, etc.).
The Sysmac Studio starts and it is imported automatically.
(2) Select [Import] in the start page of the Sysmac Studio and specify the project file.
After importing the file, perform the device settings according to the PLC model to be used
as necessary.
Device settings can be performed from [Controller] | [Change Device] in the Sysmac Studio.
4
Setting of the PLC clock
Go online to the PLC, and then set the PLC clock with [Controller Clock] of the Sysmac Studio.
(Refer to the Sysmac Studio Version1 Operation Manual (Cat. No.W504) section 8-2)
5
Parameter Settings of the Sample Program
Set the following parameters as shown in the "Sample Program Code Descriptions".
Number of data collection devices: Number of K6CM devices to be used
Data collection cycle: cycle for collecting data from K6CM devices
Connection destination IP address: IP address of the K6CM device to be connected
6
Going Online to the PLC
Select [Online] from [Controller] in the Sysmac Studio.
(Confirm that the PC and PLC are connected in advance.)
7
Changing to PROGRAM mode
Select [PROGRAM Mode] from [Controller] | [Mode] in the Sysmac Studio.
Check the contents of the caution window and select [Yes].
K6CM Motor Condition Monitoring Device User's Manual (N219)
8 Monitoring and Setting Using the EtherNet/IP Devices
Set it with the start navigation of the software tool (Motor condition monitoring tool).
Refer to 4-3-2 IP Address Setting of the K6CM Devices on page 4-26
- If you have not imported the project file in the Sysmac Studio, set it with [Connect to
Device] on the start page of the Sysmac Studio.
(Refer to the Sysmac Studio Version1 Operation Manual (Cat. No.W504) section 6-2-8)
- If you have imported the project file in the Sysmac Studio, set it with [Communications
Setup] of the Sysmac Studio.
(Refer to the Sysmac Studio Version1 Operation Manual (Cat. No.W504) section 6-2-2)
Set it from the Control Panel. Refer to4-2-2 Uninstallation Procedures on page 4-23.
8
8 - 39