Omron K6CM User Manual page 38

1 Overview
1-5 Procedure
The K6CMs can be used in the following procedure.
Step
1. Initial setting
on desk
2. Installation
and Wiring
3. Setting with
actual sys-
tem configu-
ration (via
hub)
1 - 14
Procedures
Prepare a PC with Windows 7 or higher and Ethernet
cables.
Install the software tool.
Start the software tool.
Connect the software tool directly to the
K6CM device via Ethernet cable.
Turn ON the power to the K6CM device.
Select [Create Project],
• Set the IP address of each K6CM device
• Set default parameters
• Set other parameters (when necessary)
• Download IP address and (when necessary) parameters
to K6CM device.
• (When necessary) Set the motor name (K6CM group
name) of each K6CM.
Install.
Wire.
Connect the software tool to the K6CM device (s) via hub.
(When necessary) Change the parameters and download to
each K6CM device.
Turn ON the power of the K6CM again and activate the
parameters.
↓
↓
Either order is
acceptable.
↓
▼
↓
▼
↓
↓
▼
K6CM Motor Condition Monitoring Device User's Manual (N219)
Reference
Section 4 Introduction
of the Motor condition
monitoring Tool
Section 2 Device Com-
ponents
Section 5 Installation
and Wiring
Section 6 How to Use
the Motor condition
monitoring Tool