How To Connect To The Vibration & Temperature Sensor; When Connecting Directly To The K6Cm Device - Omron K6CM User Manual

5 Installation and Wiring
5-3 How to Connect to the Vibration &
Temperature Sensor
This section describes how to connect the K6CM-VBM to the K6CM-VBS1 vibration and temperature sensor.
Appearance of K6CM-VBS1
Cable length:
0.3 m
5-3-1

When Connecting Directly to the K6CM Device

Connect the cable by matching the pre-amplifier cable colors with the K6CM device terminal num-
bers as shown in the figure below.
For details on how to use the push-in plus terminal block, refer to 5-4-2 How to use the Push-In Plus
Terminal Block on page 5-20.
Additional Information
The pre-amplifier cable uses stranded wires. You can also remove the semi-stripped end parts
and directly connect the wires, but we recommend using ferrules.
5 - 16
Cable length:
2.6 m
Connector
connection
K6CM-VB
Sensor head
K6CM-VBS
Pre-amplifier
Cable length: 1 m
1 2
3 4
The cable end is in a semi-stripped
state.
7 8
K6CM-VBS
9 10
(pre-amplifier)
Red/white
7
9 10
Black
13 14
15 16
17 18
K6CM Motor Condition Monitoring Device User's Manual (N219)
To the K6CM-VBM
Vibration & temperature
type device
Black
Black/white
Red/white
Red
Red
8
Black/white