Omron K6CM User Manual page 132

5 Installation and Wiring
Precautions for Correct Use
The sensor head and the pre-amplifier are calibrated and inspected as a set at the factory ship-
ment. Be sure to use them with the combination shipped. The sensor head cannot be replaced.
To verify the combination, check the serial numbers on the label of the sensor head and the
label of the pre-amplifier. The same serial number means the correct combination.
If you change the combination of factory shipping conditions and then use them, the value of
acceleration and the value of velocity will be inconsistent, so measurement cannot be correctly
monitored.
5 - 12
(01)04549734178730
(21)1342177281
MES:Ver.1.0
The number following (21) in the second line
is the serial number.
Make sure that this number on the sensor
head's label matches the number on the
pre-amplifier's label.
K6CM Motor Condition Monitoring Device User's Manual (N219)
(01)04549734178730
(21)1342177281
MES:Ver.1.0
OMRON Corporation
MADE IN JAPAN