Omron K6CM User Manual page 280

Appendices
Insulation Resistance Type (K6CM-ISM)
Data name
Circuit topology
Using inverter
Inverter special mea-
surement
A - 20
Description
Sets the Circuit topology.
0: Three-phase three-wire system,
S-phase grounding
1: Three-phase four-wire system,
N-phase grounding, delta connection
load
Sets the presence or absence of the
inverter.
0: OFF (No inverter)
1: ON (with inverter)
(For 3 phase 4 wires N phase ground
load side delta connection, use with no
inverter.If you have an inverter you can
not do the correct measurement.)
Sets the Inverter Special measurement.
0: OFF
1: ON
Special calculation to do when inverter
frequency and commercial frequency
are close. For how to use this function,
refer to the Wiring Diagram of the Insu-
lation Resistance Type (K6CM-IS) on
page 5-27 in 5-6 I/O wiring on page
5-25.
Note : With or without inverter = "with
inverter" only valid
Writing method (Yes: supported, No: supported)
CIP message com-
Software munications / Mod-
tool bus TCP message
communications
Yes
Yes
Yes
K6CM Motor Condition Monitoring Device User's Manual (N219)
Tag
data Remarks
link
Yes No
Yes Nos
Yes No