Monitoring Type Switching - Omron K6CM User Manual

7-2-2

Monitoring Type Switching

1
Switch the monitoring category by pressing the [DISP] key on the front of the device.
Each time you press the [DISP] key, the unit of the measurement value (monitoring category)
changes.
*1. Display auto switching mode can be used in Eip cpu version 1.20 or later.
Monitor Type
Comprehensive current
diagnosis type
Vibration & temperature
type
Insulation resistance type
K6CM Motor Condition Monitoring Device User's Manual (N219)
7 Monitoring with K6CM and Motor condition monitoring Tool
LCD indicating the unit (Monitoring
type) of the measurement value
Numeric LCD display:
The numerical value in the above
measurement unit is displayed.
Switching the Monitoring type:
Press the [DISP] key.
LCD indicating the unit of
measurement value
"Ci1"
↓
"Ci2"
↓
"A"
"G"
↓
"mm/s"
↓
"T"
↓
"ΔT"
"MΩ"
↓
"mA"
Press and hold the [DISP] key for 3 sec-
onds to switch the unit of measurement
value (monitoring type) every 5 seconds
*1
automatically.
When the [DISP] key is pressed again for
3 seconds in this state, returns to the orig-
inal state.
Monitoring category
Degradation level 1
Degradation level 2
Current
Acceleration
Velocity
Motor temperature
Temperature gap (i.e., the difference from the room
temperature of the motor temperature)
Insulation resistance
Leakage current
7
7 - 5