A-9-2 Using The Nj/Nx-Series - Omron K6CM User Manual

Appendices
6
Downloading settings
Connect online to the originator device and download the configuration settings.
(The EtherNet/IP tag data link communications setting of the K6CM series is fixed, so you do
not need to download it to the K6CM.)
(1) Online
Select the communications interface to use from [Option (O)] | [Select Interface (I)] on the
menu bar. (This operation is unnecessary if interface is not changed after interface setting. )
Then, select [Network (N)] | [Connection (C) ...] on the menu bar or click
ton) to go online to the EtherNet/IP network.
After online, select the originator device (PLC) to download, right click it and select [Param-
eter (P)] | [Download (D)] and download it.
Additional Information
For details on online and download operations, refer to the manual of the originator device.
For detailed settings, refer to the manual of the originator device.
• "SYSMAC CS/CJ Series EtherNet/IP Units Operation Manual (Cat. No.W465)"
A-9-2 Using the NJ/NX-series
With the Sysmac Studio Ver. 1.10 or higher, tag data link (EtherNet/IP connection) setting is possible
when using NJ/NX-series PLC as a tag data link originator.
 Creating Network Variables (Input)
Create Input area in the PLC to receive Input data from K6CM devices.
The setting method for the NJ/NX-series PLC is shown below.
1
Starting the SysmacStudio
Start the SysmacStudio in one of the following ways.
• Double-click the shortcut icon of [Sysmac Studio] on the desktop.
• To start the Sysmac Studio, select [All Programs] | [OMRON] | [Sysmac Studio] | [Sysmac
Studio] from the Windows Start Menu.
A - 38
K6CM Motor Condition Monitoring Device User's Manual (N219)
(Online but-