Omron K6CM User Manual page 165

• [Device setting] Button
Change the IP address of the device.
IP address, subnet mask, default gateway.
Version Information
With software tool version 1.2.0.0 or later, the column for displaying the IP addresses of your
PC and registered devices are displayed.
• [Monitoring setting] Button
Change the monitoring cycle.
Can be set in the range of 5 seconds to 366 days. (The initial value is 600 seconds.)
The monitoring cycle is the cycle at which the software tool collects measurement values
from the K6CM devices.
The measurement values are collected by the software tool at that cycle, regardless of the
K6CM device state such as the use of trigger or the determination of measurement value.
Around 1 day for the monitoring cycle is recommended.
Version Information
With software tool version 1.2.0.0 or later, the unit of monitoring cycle can be set.
K6CM Motor Condition Monitoring Device User's Manual (N219)
6 How to Use the Motor condition monitoring Tool
Using this pull down list allows you to
change the unit of monitoring cycle.
Selectable units are seconds, minutes,
hours, and days.
6
6 - 15