Omron K6CM User Manual page 14

Manual Structure
Manual Structure
Page Structure
The following page structure is used in this manual.
Level 2 heading
Level 3 heading
A step in a procedure
Indicates a procedure.
Special information
Icons indicate precautions,
additional information, or
reference information.
Manual name
12
7 Motor Monitoring with the K6CM Devices and the Software Tool
7-3 Motor Monitoring Using Software
Tools
This section describes how to monitor a motor using the software tools.
7-3-1 Monitoring Procedure with Motor Condition Monitoring Tool
It depends on the following procedure.
1
Click the [Monitoring setting] Button and set "Monitoring cycle".
2
In the upper right corner of the screen, select [Monitoring by motor category] or [Monitoring by
monitoring category] from the pulldown list.
3
Monitoring is performed on the [Monitoring by mo tor category] screen or [Monitoring by monitor-
ing category] screen.
Precautions for Correct Use
In order to monitor the K6CM with the software tool, the communications service of the SYS-
MAC Gateway communication driver between the computer and the K6CM must be in the start
status.
The status of SYSMAC Gateway's communication service can be checked on the SYSMAC
Gateway Console screen.
The SYSMAC Gateway Console screen is activated by clicking [Device setting] on the startup
screen or by clicking the [SYSMAC Gateway Console] Button on the monitoring screen.
7-3-2 Set the Monitoring Cycle
Click the [Monitoring setting] Button.
Set Monitoring cycle on the following screen.
The settable range is 5 to 99999 seconds. The default value is 600 seconds (10 minutes).
Version Information
With software tool version 1.2.0.0 or later, the unit of monitoring cycle can be set.
K6CM Motor Condition Monitoring Device User's Manual (N219)
7
Using this pull down list allows you to
change the unit of monitoring cycle.
Selectable units are seconds, minutes,
hours, and days.
7 - 9
K6CM Motor Condition Monitoring Device User's Manual (N219)
Level 1 heading
Level 2 heading
Level 3 heading
Gives the current
headings.
Page tab
Gives the number
of the main section.