Sample Program Code Descriptions - Omron K6CM User Manual

8 Monitoring and Setting Using the EtherNet/IP Devices
8
Download the sample program to PLC
Select [Transfer to Controller] from [Controller] in the Sysmac Studio.
Select [Execute] in the content confirmation window.
Select [Yes] in the execution confirmation window.
9
Changing to RUN mode
Select [RUN Mode] from [Controller] | [Mode] in the Sysmac Studio.
Check the contents of the caution window and select [Yes].
With the above operation, the sample program will be executed and data collection will be
started.
The measured data of the K6CM devices will be output as a CSV file to the SD Memory Card
mounted to the PLC.
(Note: To prevent measured data corruption, change to Program mode before you remove the
SD Memory Card.)
8-4-4

Sample Program Code Descriptions

This section shows the code descriptions of the sample program.
According to your system, set the parameter and the IP address that are described at the beginning of
this program.
The subsequent codes are not required to edit unless there is special use.
8 - 40
K6CM Motor Condition Monitoring Device User's Manual (N219)