Omron K6CM User Manual page 62

3 Measuring and monitoring System
 Example of Operation When the Trigger Mode Is "External trigger" or "Inter-
nal trigger"
• Measuring and Monitoring Not yet
The operation is the same as the operation example when the trigger mode is "Free run".
Refer to P. 3-7.
During and After Measuring and Monitoring
Measurement value
Numeric LCD
display
Status display
3 - 8
Power ON
Trigger
(*1)
start
Measuring and
monitoring Not yet
"- - - -"
Not lit.
*1. In the above figure, the power-ON state and the unmeasured state (i.e., the state
until the measurement value is calculated) that exist immediately after turning ON
the power as shown on page 3-7 are omitted.
Measuring and
monitoring period
Power ON the next time
Measuring and
monitoring
During measuring After measuring
and monitoring
and monitoring
Either the PV, the
The status at
minimum value, or the
maximum value of the the end keeps.
measurement value
"MON" Not lit.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Time
Measuring and
monitoring Not yet
"- - - -"
Not lit.