Expansion Error Code Of The Cip Message Communications; A-10-1 General Status - Omron K6CM User Manual

Appendices
A-10 Expansion Error Code of the CIP Mes-
sage Communications
This section describes the expansion error code when an explicit error occurs in the CIP message com-
munications command.
The format of the expansion error code is as follows.
Value: 16#XXYYZZZZ
Data type: DWORD
(XX: General Status, YY: Additional Status size (unit: WORD), ZZZZ: Additional Status)
However, ZZZZ of Additional Status is enabled only when XX of General Status is 01 (hex). In other
cases, size YY is 00 and ZZZZ of Additional Status does not exist.
A-10-1 General Status
General Sta-
tus (hex)
00 Success
01 Connection failure
02 Resource unavailable
03 Invalid parameter value
04 Path segment error
05 Path destination unknown
06 Partial transfer
07 Connection lost
08 Service not supported
09 Invalid attribute value
0A Attribute list error
0B Already in requested mode/state
0C Object state conflict
0D Object already exists
0E Attribute not settable
0F Privilege violation
10 Device state conflict
11 Reply data too large
12 Fragmentation of a primitive
value
A - 48
Status Name
Service was successfully performed by the object specified.
A connection related service failed along the connection path.
Resources needed for the object to perform the requested service were
unavailable.
See Status Code 20 hex, which is the preferred value to use for this con-
dition.
The path segment identifier or the segment syntax was not understood by
the processing node. Path processing shall stop when a path segment
error is encountered.
The path is referencing an object class, instance or structure element that
is not known or is not contained in the processing node. Path processing
shall stop when a path destination unknown error is encountered.
Only part of the expected data was transferred.
The messaging connection was lost.
The requested service was not implemented or was not defined for this
Object Class/Instance.
Invalid attribute data detected.
An attribute in the Get_Attribute_List or Set_Attribute_List response has
a non-zero status.
The object is already in the mode/state being requested by the service.
The object cannot perform the requested service in its current
mode/state.
The requested instance of object to be created already exists.
A request to modify a non-modifiable attribute was received.
A permission/privilege check failed.
The device's current mode/state prohibits the execution of the requested
service.
The data to be transmitted in the response buffer is larger than the allo-
cated response buffer.
The service specified an operation that is going to fragment a primitive
data value, i.e. half a REAL data type.
Description of Status
K6CM Motor Condition Monitoring Device User's Manual (N219)