Omron K6CM User Manual page 303

4
EtherNet/IP Connection Settings
After creating the network variables (input), perform setting the EtherNet/IP connection for Eth-
erNet/IP tag data link communications.
(1) Opening the EtherNet/IP Device List Tab Page
Select [EtherNet/IP Connection Settings(N)] from the [Tools(T] from the menu bar.
(2) Opening the EtherNet/IP Connection Settings (Tag Set Display)
Select the EtherNet/IP originator device and double-click it, or right-click the originator
device and select [Edit (E)]. If you use the built-in EtherNet/IP port, only the built-in Ether-
Net port is displayed as an originator device. In that case select it, highlight it and then
operate it.
(3) Rregistering the K6CM Devices to the Network
Make the following settings so that the K6CM device operates as a target.
(3)-1 Installing EDS Files
To configure K6CM as an EtherNet/IP tag data link communications target, install the EDS
file containing the configuration information of the K6CM in the SysmacStudio. Once this
installation is done, this operation is unnecessary from the next setting.
This operation is unnecessary because it is preinstalled if you use the SysmacStudio
Ver.1.40 or higher. If you are using an earlier version, install it using the EDS file stored on
the CD shipped with the K6CM device.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Appendices
A
A - 43