Omron K6CM User Manual page 114

4 Introduction of the Motor condition monitoring Tool
When the connection is successful, the following [IP address setting] wizard screen will be dis-
played.
Additional Information
Click the [Suspend] Button to abort the connection.
Version Information
With software tool version 1.3.0.0 or later, a message appears to notify that processing will be
in accordance with the connected device if the Eip cpu version of the connected device differs.
For details on each version compatibility, refer to A-11 Version Compatibility A-51 on page A-1.
9
In the "Set the connecting means for the target device.", set the following.
Check one of the following check boxes.
• Acquired from BOOTP server
• Fixed setting with IP address acquired from BOOTP server
• Fixed setting
When "Fixed setting" is checked, set the IP address, subnet mask, default gateway.
Note When "Fixed setting with IP address acquired from BOOTP server" or "Acquired from BOOTP
server" is checked, set the IP address to be acquired from the BOOTP server here.
If the device obtains a value different from that value from the BOOTP server, the Motor condition
monitoring Tool will not be able to access that device. In that case, delete the relevant device with
the [Delete device] Button of the tool buttons, and then re-register the device with the IP address
obtained from the BOOTP server by the [Add device] Button.
Precautions for Correct Use
When setting the IP address of the K6CM to "Fixed setting", set the IP address of the computer
to the IP address of the same segment as the K6CM.For details of the setting method, refer
to4-3-1 IP Address Setting of Your PC on page 4-24.
4 - 32
K6CM Motor Condition Monitoring Device User's Manual (N219)