Omron K6CM User Manual page 80

3 Measuring and monitoring System
Behavior When Self-Diagnosis Error Occurs
 K6CM Device
Numeric
Error status LCD dis-
Hardware ---- lit Or
errors 8888
flashing
Communica- ---- lit
tions error
with Vibra-
tion & Tem-
perature
sensor or
Insulation
Resistance
sensor
Hardware There is
error for run- no state
ning time change
function due to
error
occur-
rence.
 Vibration & Temperature Sensor
Error status
Hardware errors
3 - 26
MS ERR
indica- indi-
output
play tor cator
Lit red Lit OFF
Flash- Lit OFF
ing red
Flash- Lit OFF
ing red
Pre-amplifier fault indicator
Lit
Tr3 Main body
status
Since the Turn ON the power again. If it returns to
message normal, the influence of noise is possi-
communica- ble. Then, check whether noise is being
tions cannot generated.
be per-
If the condition does not restore, contact
formed, the
your OMRON representative.
Main body
status can-
not be read.
Mes cpu • Make sure that wiring is correct.
error turns
• Turn ON the power again. If it returns
ON.
to normal, the influence of noise is
possible. Then, check whether noise
is being generated.
If the condition does not restore, contact
your OMRON representative.
Main CPU • Make sure that the ambient tempera-
error turns ture of the K6CM device does not
ON. exceed the operating ambient tem-
perature.
• Turn ON the power again. If it returns
to normal, the influence of noise is
possible. Then, check whether noise
is being generated.
If the condition does not restore, contact
your OMRON representative.
Turn ON the power again. If it returns to normal,
the influence of noise is possible. Then, check
whether noise is being generated.
If the condition does not restore, contact your
OMRON representative.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Corrective action
Corrective action