Omron K6CM User Manual page 61

 Example of Operation When the Trigger Mode Is "Free run"
• Measuring and Monitoring Not yet
The following is an example of the operation from the time the power is turned ON until the mea-
surement value is calculated. In any case, Free run (no trigger) and external trigger and internal trig-
ger, the same operation occurs.
Power ON
(*1)
Alarm bar
Numeric LCD display
Status display
ON
Transistor Output 1
OFF
ON
Transistor Output 2
OFF
ON
Transistor Output 3
OFF
*1. PV of the measurement status is unmeasured status.
*2. Even if setting the transistor output method of outputs 1 and 2 to "Normally Open" or "Normally Close",
the above operation will be performed from immediately after turning ON the power supply until mea-
surement starts. The operation according to the setting is started at the start of measurement.
• During Measuring and Monitoring
Measurement value
Power ON
(*1)
Numeric LCD display
Status display
K6CM Motor Condition Monitoring Device User's Manual (N219)
At the start of power Monitoring, Not yet (*1)
One sampling period
Approx. 2 seconds
Note: Sampling period depends on
No lit.
LCDAll lit.
When the trigger type is Free run: "MON"
LCDAll lit. When the trigger type is internal or
external trigger: Not lit.
Measuring and monitoring period
Measuring and monitoring
During measuring and monitoring
Either the PV, the minimum value,
or the maximum value of the measurement value
"MON"
*1. In the above figure, the power-ON state and the unmeasured state (i.e., the state until
the measurement value is calculated) that exist immediately after turning ON the power
as shown below are omitted.
3 Measuring and monitoring System
measurement value and setting
No lit.
"----"
Self-diagnosis: Normal: ON
Error: OFF
Power ON the next time
or the maximum value of
the measurement value
Time
During monitoring
Time
Measuring
and monitoring
During measuring
and monitoring
Either the PV, the
minimum value,
"MON"
3 - 7
3