Marker:bsource <Character_Data - Keysight 8990B Programming Manual

MARKer:BSOUrce <character_data>
This command sets the source of marker B.
Prior to sending this command, you need to set the marker measurement mode
NOTE
to WAVeforms, FLOAt, DELay, or SPACing (refer to
<character_data>"
Syntax
Parameter
Item Description/Defaul t
character_data Sets the marker B source as:
– NONE: Disables the source.
– CHAN1: Sets the source to channel 1.
– CHAN2: Sets the source to channel 2.
– CHAN3: Sets the source to channel 3.
– CHAN4: Sets the source to channel 4.
– WMEM1: Sets the source to waveform memory slot 1.
– WMEM2: Sets the source to waveform memory slot 2.
– WMEM3: Sets the source to waveform memory slot 3.
– WMEM4: Sets the source to waveform memory slot 4.
– FUNC1: Sets the source to waveform math function 1.
– FUNC2: Sets the source to waveform math function 2.
– FUNC3: Sets the source to waveform math function 3.
– FUNC4: Sets the source to waveform math function 4.
[a] These parameters are not applicable when the marker measurement mode is set to DELay or SPACing.
Keysight 8990B Programming Guide
on page 321).
:BSOU
MARK
Space
character_data
?
MARKer Subsystem
"MARKer:MODE
Range of values
[a]
NONE
CHAN1
CHAN2
CHAN3
CHAN4
[a]
WMEM1
[a]
WMEM2
[a]
WMEM3
[a]
WMEM4
[a]
FUNC1
[a]
FUNC2
[a]
FUNC3
[a]
FUNC4
11
311