Ese <Nrf - Keysight 8990B Programming Manual

2 IEEE-488 Command Reference
*ESE <NRf>
The *ESE (Event Status Enable) command sets the bits in the Standard Event
Enable register. The selected bits are then reported to bit 5 of the Status Byte
register. The <NRf> parameter is used to specify which bits will be enabled. The
specified decimal value corresponds to the binary-weighted sum of the bits you
wish to enable in the register. For example, to enable bit 2 (decimal value = 4), bit
3 (decimal value = 8), and bit 5 (decimal value = 32), the corresponding decimal
value would be 44 (4 + 8 + 32).
The following table lists the bit definitions for the Standard Event register:
Table 2-1 Bit definitions: Standard Event register
Bit Weight/Decimal value
0 1
1 2
2 4
3 8
4 16
5 32
6 to 7 –
Refer to
Syntax
50
"Standard Event register"
Space
*ESE
?
Definition
Operation complete
Not used
Query error
Device-dependent error
Execution error
Command error
Not used
on page 40 for more details.
NRf
Keysight 8990B Programming Guide