Status Register Set Commands - Keysight 8990B Programming Manual

Peak power analyzer

Hide thumbs Also See for 8990B:

Table of Contents

STATus Subsystem

Status Register Set Commands

This section describes the five status register set commands. Each can be used to

examine all of the status registers listed on

To apply a command to a specific register, prefix the command with the name of

the appropriate register. For example, to apply the :ENABle command to the

STATus:QUEStionable register, use the following command:

STATus:QUEStionable:ENABle

The status register set commands detailed in this section are:

:NTRansition

:PTRansition

This query returns a 16-bit decimal-weighted number representing the bits set in

the Condition register of the SCPI register set you require to control. The return

format is <NR1> in the range of 0 to 32767 (2

Parameter form

[query only]

–1). The contents of the Condition

Keysight 8990B Programming Guide