Table of Contents
Advertisement
TIMebase:REFClock <boolean>
This command sets the state of the reference signal of the 10 MHz REF IN BNC
input.
Syntax
Example
TIM:REFC ON
Remarks
– If there is no reference signal at the 10 MHz REF IN BNC input, this command
– This command is only applicable when the ETS mode is disabled. If you send
Reset condition
On reset, the 10 MHz reference signal input is turned off.
Keysight 8990B Programming Guide
TIM
:REFC
This command turns on the 10 MHz reference signal input.
will set the state to OFF even if the state is ON. Also, error 720,"Settings
conflict;No reference signal detected on the 10 MHz REF IN BNC input" will
occur.
this command when the ETS mode is enabled, error 940,"Unable to turn on 10
MHz setting when ETS is on" will occur.
Space
0|OFF
1|ON
?
TIMebase Subsystem
7
193
Advertisement
Table of Contents
