Table of Contents
Advertisement
CALibration:CALibrate:AUTO <boolean>
This command sets the state of auto calibration performed on channels 1 and 4.
You can set the time interval to run the auto calibration using
"CALibration:CALibrate:AUTO:INTerval <numeric_value>"
Syntax
Example
CAL:CAL:AUTO 1
Remarks
– For seamless remote operation when auto calibration is enabled, you are
Keysight 8990B Programming Guide
CAL
:CAL
advised to incorporate sufficient timeouts (10 secs) in your test program to
avoid errors. Alternatively, the
before proceeding to the next command.
Space
:AUTO
This command enables auto calibration on channels
1 and 4.
*OPC
command can be used for status checking
CALibration Subsystem
on page 149.
0|OFF
1|ON
?
5
147
Advertisement
Table of Contents
