Function Diagrams And Parameters; Messages Via Diagnostics Channels - Siemens SINAMICS S120 Function Manual

11.3.9.7

Function diagrams and parameters

Function diagrams (see SINAMICS S120/S150 List Manual)
• 2381
• 2382
• 2610
Overview of important parameters (see SINAMICS S120/S150 List Manual)
• r5600
• p5602[0...1]
• p5606[0...1]
• p5611
• p5612[0...1]
• r5613.0...1
11.3.10

Messages via diagnostics channels

Messages can be displayed not only via the well-known commissioning tools (STARTER,
SCOUT). After the activation of a diagnostic function, the messages are also transferred to
the higher-level controller via the standardized diagnostic channels. The messages are
evaluated there or forwarded for convenient display to the corresponding user interfaces
(SIMATIC HMI, TIA Portal, etc.). The messages are shown on the respective user interfaces
similarly as in STARTER.
In this way, problems or faults can be located immediately regardless of the tool currently
being used, and then corrected immediately.
Also note the general information on the diagnostics channels in Section Diagnostics
channels (Page 670).
Drive functions
Function Manual, (FH1), 04/2014, 6SL3097-4AB00-0BP4
PROFIenergy - Control commands / query commands
PROFIenergy - States
Sequence control - Sequencer
Pe hibernation ID
Pe hibernation pause time, minimum
Pe hibernation duration, maximum
Pe energy-saving properties, general
Pe energy-saving properties, mode-dependent
CO/BO: Pe energy-saving active/inactive
11.3 Communication via PROFINET IO
Communication
751