Siemens SINAMICS S120 Function Manual page 394

Basic functions
7.28 Web server
Enabling users
The "SINAMICS" and "Administrator" users can be enabled with their specific rights. It is also
possible to specify whether a password protection should be active for the respective user.
The "Administrator" user has the full rights as standard. However, only restricted access
rights apply for the standard "SINAMICS" user.
Note
Secure passwords
SINAMICS does not specify any password rules for the assignment of passwords. You can
therefore assign any passwords without restriction. STARTER does not make any checks for
illegal characters or passwords which have already been used. Therefore, as the user, you
are responsible for the required password security.
Use a sufficiently long password (max. ten characters). Use special characters and avoid
passwords which you have already used elsewhere.
Please note that if the Windows language settings are changed, errors can occur when
subsequently checking the password. If you use language-specific special characters, you
must ensure that the same language setting is active on the computer for subsequent entry
of the password.
To enable a user and activate a password for read and write access, proceed as follows:
1. Click the checkbox of the user you want to enable (e.g. enable "SINAMICS" user, etc.).
2. Click the "With password" option button in the corresponding setting area.
The "Specify password" button below the option button then becomes active.
3. Click the "Specify password" button.
The "Web Server - Specify Password" dialog box opens.
Figure 7-28
4. Enter the new password (max. ten characters) in the "New password" field. Pay attention
to upper and lower case.
5. Repeat the input in the "Confirm password" field.
For security reasons, the password entries displayed in the two input fields are encrypted.
394
Specifying the Web server password
Function Manual, (FH1), 04/2014, 6SL3097-4AB00-0BP4
Drive functions